Tea Shop Floor: I have been in several small sandwich, or tea shops that have a wood floor, but have painted-on rugs. One painted rug has a medium green center and a 7 inch white border with red roses. I suppose you would have to paint the rug on the floor before you put on the ceiling. MAP in Puyallup |
Amazing Playscale designer chairs: I was browsing thru the MOMA (Museum of Modern Art) online store the other day and I discovered these amazing little modern designer chairs: Maura Bass |
HUMMEL PLATES: Dolores who was looking for these earlier this week, go to www.tias.com and you'll find enough to stock a china shop. They even look like the right size to fit buttons or soda cap liners without manipulation, just printed right off the site. Loretta Sniarowski |
Ice Cream Parlour: I have the book Building Masterpiece Miniatures by Joseph Daniele (ISBN 0-8117-0306-1) published in 1980 and it has an entire chapter devoted to making an ice cream parlour, including the furniture, fixtures and apartment. Is this the book you meant? Maybe you can order it from one of the used book sources such as www. abebooks.com or www.bn.com. This is a great reference book and hope this info helps. Cheryl |
Contacting Corona: All the info you need on Corona's dollhouses is available from their website: http://www.corona-concepts.com/ Joy Perkins |
Contacting Corona: 10 Depot Street, Schenevus, NY 12155, www.corona-concepts.com Carol |
1/144th Shingles: What I did for the 1/144th. log cabin shingles (thanks to suggestions from this group) was cut fine grain tan sandpaper in 1/4" strips. Then I cut it like fringe and glued it on in strips overlapping each strip. They can be a little longer than your roof. Once the glue was dried (overnight), trim the strips that hang over to make the roof edge neat. I used a Min-Wax stain pen to color it like I wanted. The stain will color the edges of your cuts darker and it gives you the effect of separate shingles. There are also some shingle strips and sheets made for N and HO railroads that will work well for 1/144th. My sandpaper ones were actually a bit big when all was said and done. If I had cut the fringes smaller, it would have been closer to scale. John Medeiros |
Glue Micro-Scale Pieces: Building micro scale (1:144) minis, I frequently don't use "glue" at all. I bond most of the tiniest parts where strength is not crucial with clear lacquer. It penetrates wood deeply, allows a little bit of shifting into place, and doesn't "fatten" the joint. Some sort of light clamping is suggested but only to maintain alignment. I good trick is to press the parts into a pad of soft clay. When you have an impression that will hold the parts in alignment, glue with lacquer and set in place. Lacquer IS NOT STRONG! For tiny, single-point connections such as a Kachina head dress to a head, drill a pair of #80 holes and insert a piece of fine wire (with lacquer) to connect the parts. If the parts are too small to drill, see if you can razor cut very shallow grooves that will be out of sight (In the back?). Lay a fine piece of wire or thread into these grooves to reinforce the joint. For very fine wire, cut the insulation off of a bit of "lamp cord". Very fine stuff. If you still can't fix the Kachina, put the pieces on a piece of miniature newspaper with a bottle of miniature glue and some miniature toothpicks and set the whole display on the kitchen table. Mel Koplin |
The Heritage: To the person that is building the Heritage go to Jim's web site http://www.printmini.com/ of Jim's Printables fame. He built the Heritage and has step by step photos and talks about the mistakes he made along the way. Elizabeth |
Edwardian Toys: Someone asked how to make mini dolls for an Edwardian Toy Shop - I didn't answer right away as I wanted to check the time line to make sure I knew what I was talking about: Edwardian refers to the time during King Edward VII 's reign which was 1901- 1910. So that gives you loads of possibilities for dolls and toys. If you can't afford finished mini-mini dolls, you can make some out of Sculpey (Just use a little ball for head and tinier balls for hands) stuck on wire, which you can wrap with stuffing and then dress. Or I've seen dolls with heads made of beads with faces painted on. You can paint a tiny plastic baby doll with matte flesh-colored paint to resemble bisque. Look on the back cover of the Leffie Lane paper doll book (By Dover publications) for all kinds of toys from that time - those particular paper dolls appeared from 1908 - 1910. Besides dolls, there are other toys: a clown doll, a monkey, a lamb on a rolling platform, toy elephant, dog and bunny, doll carriage, doll bed and furniture, a roadster, stuffed bears, toy pony, and an oriental doll. Other ideas are jack-in-the-box, marionettes, balls, boats, and of course a dollhouse with furniture. Sounds like fun. And a lot of these things can be made from little plastic toys and charms and stuff you might have in your junk drawer. Paulette from Indiana |
| Previous 10 | Next 10 Page 460 of 1032. Total links in database: 10312. |
|
Browse the database (all entries) |