Cobblestones: Cobblestones are easy to make using plaster of Paris or hydrocal. Just mix some up in a paper cup and drip onto a piece of waxed paper. Then let dry, peel them off, paint as you would like and pave your street with them.

Alice Zinn


Removing Soda cap liners (to make plates with): I remove the bottle cap liners (soda & juice jugs) with a dental pick. Friends of mine use a needle. Put the tip of your tool of choice along the outside edge of the bottle cap liner and slide tip down under the edge and lift with the point. It should easily lift up so you can get hold of it.

Bobbie


Removing Soda cap liners (to make plates with): I've had luck using an old pair of shears to cut down the cap side across the screw top grooves. I usually make 2 parallel cuts about a half inch or so apart going from the cap edge almost to the liner. No need to be neat but be careful not to damage the liner with the tip of the shears. This leaves a sort of tab on the cap that you can pull down and away exposing a little bit of the liner which can now be pried up more easily.

Once out, you can use a small flat round button or even a US dime centered in the cap and trace around it a few times with a ball point pen. I find this gives the liner a more realistic shape, curved and with a rim of sorts. Just my method. I'm sure there's plenty more out there as this board is exploding with great ideas.

Something I've just recently found to make an even better plate are the white plastic pull rings that seal cardboard cartons of OJ. They need a little careful snipping to separate the pull ring from the solid round disk attached to it. If you make a slight mistake you can always cover it with a small piece of food. I'm proud to say my DH came up with this one.

Chris


Calculating Precise 1:12 Scale; Here's a simple way to get a precise measurement of your item converted without having to do any fancy math. (Or without trying to smuggle an Imperial ruler into the country. LOL)
Get a piece of drawing paper or better, something more durable such as a piece of Plexiglas or a sheet of metal. Make sure it's smooth, flat, has a straight edge, and is longer than one foot and approximately 6 inches wide (15 cm).
Draw a line that's exactly one foot long, 3.048m (or scratch it into the metal with the tip of a sharp knife). Draw the line so it's parallel with the side of the paper. Mark one end of the line with "0" and the other with "12." At the end of the line marked "12", draw a right angle making this line exactly one inch tall 2.54 cm. Now turn this into a triangle by connecting back to the "0" end. You'll have a low, long triangle.
To convert any measurement from full-scale to 1:12 scale, all you have to do is set the item on the base of the triangle always starting at the 0 end of the scale. Put a carpenter or machinist's square on the edge of your Plexiglas and push the straight edge against the end of the object you're measuring. The square blade will cross the 0-12 line vertically. At the point where the square intersects with the hypotenuse of the triangle,
you now have an exact 1/12th measurement of the object. You don't need to worry if the piece was originally 3 1/64 or 3 9/16. All you need to do is measure the width of the short leg of the triangle where your square is sitting, and you have the exact measurement without doing any math.
This is especially helpful when you're trying to do measured drawings of a piece of furniture. Using this method, I was able to build a miniature replica of a delicate secretary's desk that belonged to my grandmother.

George Held, Cedar Rapids


Bookbox: I've been making bookbox room displays for over 20 years now. I've taught 2 classes at the Guild School about them and did a Theme Luncheon at the NAME national last year on them. I read Diane's description of how she made her bookbox room. Her description was quite detailed and although this is not exactly how I do mine (Do two people ever do things exactly alike? LOL), I want to add one strong suggestion, that is: to make the inner box out of wood. Most books need the extra support from a
good foundation box inside. The paper covering of the foam core will tear and the "foam" will bend if stress is put on the setting.
Another serious reminder is to remember all the safety rules when you are operating the saws. The books need to be cut with big power tools and you need to be especially careful around these.
If you would like to see some of the ways I've made books into displays, feel free to visit my website.
http://www.gate.net/~mgm/minis.html
I've just added some new pictures of workshops that I will be doing in the future and of my display that I will be showing at the IGMA show coming up. I am working on some new things for that show.

Shannon Moore


Onionskin Paper: I had a large package of onionskin, too, and have found many uses for it.

One is old book pages. Painted with watered down acrylics it's useful for punched flower petals. I have also used it for hinging lightweight items and for strengthening awkward sized glued pieces that were going to be covered with something else.

One of the ways I figured out how to use it was to just slop on all kinds of paint and see what it reminded me of. Then I glued it on wood, cardboard and plain paper to see if that suggested anything. Glued to cardboard and painted it looked like leather. Gluing it between acetate sheets gives the pebbly look of the glass doors and transom windows in old buildings. Painted with acrylics it makes tortillas.

There are other uses which I can't recall at the moment. Just don't throw it away; experiment.

Wanna in El Paso


Stunning modernist dollshouse: I just saw a stunning modernist dollshouse in my local toy shop. It is called the Kaleidoscope House, by Bozart, designed by Laurie Simmons and Peter Wheelwright. It is 1:12 scale and its walls are sliding coloured Perspex so that as they are overlapped new colour effects appear. The colours caught my eye from across the street this morning as I was dropping off the girls for school, so I went back once the shop was open and got the details to share. It has a two story living room with open plan kitchen, balcony over the living area from the upstairs, battery powered light in the open plan kitchen. The curved roof lifts off for access, as well as all the wall panels sliding for 4 sided access. There are also assorted modern furniture and accessory sets, including a set of modern art and sculpture, all by named artists. It assembles without tools and the shop assistant said that it was sturdy. It is recommended for ages 6 and up. Have a look at the detailed website at http://www.bozart.com second page, Kaleidoscope House. They have lots of colour photos and virtual tours. Definitely different from Victorian.

Wendy in Clinton, NJ


Finding a good show:
1. Finding a "Good" show- may be harder than it sounds. There are many 'good' shows, but some are not so easy to get into. A lot depends on your merchandise for sale. Like most of us, you may have to do little local shows first. and as they say 'pay your dues', just like starting out in show business. If you are good, the show promoters will find you!
2. What is a 'good' show? That is subjective! A good show is any show where you make what you consider an acceptable amount of money! There are shows with good reputations, however, and these are often the ones it takes time to get accepted to.
3. Pricing- You are right, pricing is a huge issue. A lot of what you charge depends on what you want out of this business. Is it just a way to supplement your mini collecting money, or the income from another full time job? Do you want to make a living at it? Do you intend to wholesale somewhere down the line? If so you must 'build in' a discount to your retail price, usually 50% off of retail.
4. Cheaper Prices- You asked if selling a comparable product for less money than others would anger them. my answer is, only your competition! Your customers would love it! Just remember this, taking into account that ethical behavior only serves to further your reputation, business is business. Just make sure that you don't make your prices so inexpensive that if you are asked to make a few dozen of something, it is still worth your while! The first one, or few are fun, dozens can get pretty boring!
5. Odds and Ends- The odds and ends you bring to a show depend on whether the show is local, or you will be staying over. For any show you may need things like: bags, order pad with your name and address on it, pens, a calculator, tissue paper, a garbage bag, money box and sufficient change, a pad for notes, a catalog or price sheet, business cards, a cooler with drinks or lunch and the like. Obviously, if you are traveling, you need clothes, toiletries, makeup, any medications you may need etc.

Alice Zinn


"Good" shows- How well you do often depends more on your costs than your sales. We did extremely well at a major show but after hotel, travel, and table costs our profit came out to be about the same as we do at some of the smaller shows close to our house.
If you have a web site, you may not do well at the show itself, but you may pick up new customers for your website. When customers see you at a show, and the quality of what you sell, they are more likely to buy from you from your website. Make sure to have plenty of business cards with your website on it.
Don't judge a show based on one time. We had very good sales at a show and the next year it was a bomb and the following year it was good again.
I have a checklist of things to bring to shows which is very useful (providing I go over the checklist before we leave). Other dealers are helpful and we have been both a borrower and a lender. Don't forget about lighting and extension cords and packing materials and a table cover. If you're going out of state make sure to check with the promoter regarding sales taxes. In some states you need to have your own tax license, in other states the promoter will get temporary ones.
Our first few shows were definitely learning experiences.

Carol


For the person who inquired about shows: I'd like to add to the comments made so far. I would say to start with a small local show. They tend to be so friendly and easy on the nerve. You will build up clientele and get a chance to ask questions of your neighbors. My best source of knowledge when I first started. Usually these are more cost efficient since you can save on the extraneous costs associated with doing shows...travel, shipping of stock, hotels, etc. In addition, at these shows you can usually find other dealers that can recommend, first hand, other shows to do. Many will be able to give to contact names of show promoters and the pros and cons on doing these shows. You can look around and see what others are using for their displays, packaging, etc. A wonderful way to certainly eliminate "guesswork" for a newbie.

Pearl


Previous 10 | Next 10


Page 508 of 1032.

Total links in database: 10312.



Search for:


Browse the database (all entries)