Tin roof knock-off. Take corrugated cardboard and remove either layer of the covering paper. This leaves you with a hill and valley cardboard sheet. You can paint this tin color and rust color. OR get some aluminum foil and press it into the hills and valleys and then spray it with hair spray. When the hair spray is dry you can paint the aluminum foil with no problem. Cost=$0.00.

Dr Bob


I have a card board roof (corrugated) on a mini that has been out doors in Florida I.E. hot and humid with no ill effects.

Dr Bob


Tougher tin roof: The idea of using corrugated cardboard to make a tin roof with ridges is a good one. But even painted, the roof ridges would tend to be dented or flattened with handling. So maybe it would add strength to the roof if you first gave the cardboard a few coats of gesso and then applied the silver paint and aging paints. Anything that would make the ridges harden would work to make this roof a more permanent one.

Darlene from L.I.


Tin Roof: Tin roof doesn't have to be corrugated. On my project I drew vertical lines 1" apart on the roof and glued on 1/16" stripwood on the lines. Then I painted the roof with 2 coats of acrylic silver paint. I haven't had time, but I intend to age it with some raw sienna. In the shop we carry a plastic corrugated roof. It looks very realistic painted with the silver acrylic.

Deanna from beautiful downtown Thiensville


Tin roof aging: If the roof is made from aluminum I found that if I apply household liquid ammonia to aluminum it gets a sort of patina. A darkening of the surface.

Dr. Bob


Tin Roof: I came across article in "Creative dollhouses from kits" by Robert Schleicher, on how to make a tin roof. Many of the ss replies were same: gluing 1/16" sq. strips to roof, no wood strip needed at edge. Divide evenly across span. Coat the entire roof with clear silicone bathtub caulk compound, and cover it with heavy duty aluminum foil. Paint the roof silver. When the paint dries, spray roof with Testors Dulcote to give it the gray look of weathered tin.

Alice P.


Finishing Rough Edges of House: I have used a thin layer of wood putty over rough wood and then sanded it after the putty was dry. It came out very smooth. It acts as a "filler" and you don't have that heavy grain to deal with.

Marjorie in CA


Finishing Rough Edges of House: I use vinyl spackling compound to fill in and smooth the edges of plywood dollhouse parts. Especially for die-cut houses, I couldn't work without it. Just apply it with your finger, press it into the edge and then wipe off any excess with a paper towel. No waiting for it to dry. You can paint right over it.

Sally Cook-Thomas


Finishing Rough Edges of House: I seal the edges of my work with plain white spackle. It is easy to sand smooth. I use plain wood putty if the edge needs to be stained. I use a large emery board for sanding. (the type they use for sculptured nails) It does not harm the finish and is easy to handle.

Becky


Finishing Rough Edges of House: I have seen houses where the edges were covered with a thin strip of veneer. Looked very nice. I think I will try that on my house...

Asa in Fairfax VA


Previous 10 | Next 10


Page 514 of 1032.

Total links in database: 10312.



Search for:


Browse the database (all entries)