Western Resource: There's an amazing on-line catalogue of western items at http://www.miniworld.com/cgbin/catalog-h.cgi Click on "Frontier" It's pricey stuff and most of it is along the lines of furniture and high-end decorative items.

Chryssa Sharp


Dremel Safety: When working with your Dremel, to be sure to wear "safety glasses" of some sort. Safety goggles are best--keep them with the tool, but if you normally wear full glasses (as many of us must), that is almost as good (though sides of eyes are unprotected from flying shrapnel). I know it is inconvenient, but isn't an unexpected eye injury worse? Think of the mini supplies you could buy, or the time you could spend reading SS, when you are tempted just this once to skip the eye wear.

Xmas Carol


Holeless Beads: I have the holeless beads in stock, but only the small size.

Dolly's Mini Dry Goods Emporium
55 B Street, Northumberland, PA 17857-1260

fiettao@cs.com
http://ourworld-top.cs.com/fiettao/myhomepage/business.html


Salvaging Slate Tiles: When salvaging slate tiles from old houses, BE SURE THEY ARE REALLY SLATE. There was some faux slate, usually used for siding in the 30s that is really a manufactured compound rich in asbestos. I know they used fancy machines and big dollar people to strip the stuff off of my boyhood home in Cleveland.

Mel in Vegas


Cutting Plexiglass: I have cut many miles of plexiglass over the years, and the best thing is a power saw of some sort. I have used both a jig saw and a band saw. You will end up with a bit of 'fuzz' on the underside of your piece, but it can be brushed off by hand. I have heard you can score thin plastic with a sharp knife and then snap it on a table edge or something similar, but have never tried that method.

Dani Rice


Asbestos in building components: Asbestos siding was grained to look like shingles most times, asbestos roof shingles look very much like slate, asbestos floor tiles were one of the first things outlawed when asbestos became a health issue and if you ever take ceramic tile off the walls of a 50s home you will find that the mastic had asbestos fibers in it?! Folks, be careful. I finally painted the mastic (new tile didn't go quite as high as the old) and replaced the front board of the bathroom sink because nothing would dissolve that stuff and I even tried a hoof rasp to remove it before we found out it was an asbestos based product ! I had a cousin in TN in the building trades who lost his life to asbestos.

Mary Lou Prechtel of Middleburg Hts., OH


Cutting Plexiglass: The folks at Home Depot were out of the little tool when I asked, but said to score the sheet lightly with a utility knife with a sharp blade, using a straight edge to keep the cutting line straight. Put it on a straight edged surface, like a table or workbench, hold down the uncut side and hit the piece you want to break off with your hand. Should snap cleanly. Mine did.

Patricia LeBeau in Florida


Power Tool Safety: The most important thing to keep in mind is safety, safety, safety. I believe in overkill to prevent accidents. Use a face shield whenever working with saws or any tool that can kick back (or that can cause wood to kick, split, or slip in any way.) Use clamps, push sticks, feather boards, etc. to keep your fingers away from blades. Sometimes it seems it would be okay to just do one quick cut, but all it takes is one quick accident. Even using protection, be sure to also be conscious of where your fingers are, and where the cord on your tool is located. I move my miter saw around and I want to be sure the cord hasn't crossed under the blade when I wasn't looking. Keep your feet firmly planted and slightly apart for balance, and keep your body out of the line of 'fire' if the wood should kick back. One of the most dangerous tools I use is a mini chain saw that works on an angle grinder. It is a wonderful sculpture tool, but I wear a leather apron, leather gloves, and I use a full face shield. I also use a dust mask when working with woods because many woods are toxic if the sawdust is breathed. These are just common sense rules, but you would be surprised at how many men are missing fingers because they don't take the extra precautions. I hope this does not discourage any would be DIYers, the tools are really wonderful and lots of fun - plus you have a real sense of satisfaction when you make something from start to finish.

Jacqui in Hilo, HI


DIAMOND DUST is crushed glass so be careful when you are using it that you don't get it in your eyes or imbedded in your hands, etc.

Marsha Hedrick


Clear Display: I have used an inverted 10-gallon aquarium as a cover for a scene quite successfully. I found one with a clear bottom at the local mega-pet store (big store, not pets) for about $12.00. I built my scene on a styrofoam base that I cut to the size of the aquarium opening.

Chris in Minnesota


Previous 10 | Next 10


Page 589 of 1032.

Total links in database: 10312.



Search for:


Browse the database (all entries)