Attic Wallpaper: Just a thought, but how about scanning in some full sized newspapers, resizing the pictures to teeny...(not a official scanning size, I'll admit!) and then printing on a yellowish paper? At this time of the year all the catalogs come out, and some have reprints of old newspapers..."The year you were born" type of thing. (There must be some other way of getting copies of old newspapers, but I can't think of where that would be.)

Kaye in L.A.


Stabilizing butterfly wings: I use a clear laquer spray to give them 2 thin coats to prevent flaking, then paint a thin layer of petal porcelain on either side to strengthen them and give the wings flexibility. The petal porcelain dries clear. If preferred you can apply 2 coats to the wings to give them strength.

Karin in South Africa


Attic Wallpaper: One of the miniature wallpaper companies makes a wallpaper pattern that looks like old newspapers. I used it on my Heritage attic walls. Pictures here: http://gerdesdesign.com/hobby.htm

Check with a dollhouse store in your area, or one of the online ones if there is no local one.

Anne Gerdes


Wallpapering Tips: Decide what each room will be, and then select papers - average 2-3 sheets of paper per room. In minis, we usually do not try to 'match' patterns, like in the real world of wallpapering. One sheet for each wall, or less if the room is smaller. Do the back wall first, slightly wrapping a little bit of the edges (right and left sides of the paper), so that those edges cover a bit of each left and right side wall.....this will give you just a bit of 'boo-boo' advantage when you paper the side walls. Papers are usually 'taller' than your walls,leaving excess to trim off at the ceiling or floor. BE CAREFUL if you have wired....don't forget that wiring is underneath those papers - :) If you cut off the excess paper, you may cut right through your wiring - YIKES!

To avoid that, I usually make 'patterns' from plain paper to fit each wall, then cut the wallpapers from this...they will fit almost perfectly when you paste the papers to the walls. If you are a 'bit short' at the top or bottom, just hide this with crown moldings and/or baseboards.

Laura in OKC


Filling Wall Seams: I used wood putty to fill the seams in the walls/siding. I used water-based putty, then sanded smooth, and the seams do not show under my wallpaper.

Michelle Fox


Wallpapering Tips: I found the easiest way to wallpaper was to make templates first using drawing paper that's not too thin. You'll find the same templates can be used for more than one room. If your house has rooms of the same size but different heights - just adjust accordingly. You will also find it easier when matching patterned wallpaper as you can lay out the templates on the wallpaper with the pattern all lined up. I paper the side walls first allowing a small amount of paper to go around and onto the back wall. The back wallpaper is cut to exact size and can then be put on last to cover these overlaps leaving no gaps. I use ready mixed border adhesive but it does not give any time to maneuver so is probably not to everyone's liking. After pasting the paper and placing it on the wall, I smooth it over GENTLY with a piece of soft dry kitchen towel to get rid of air pockets. The thing to remember is it doesn't matter if you do it and it goes wrong. It only takes a minute or two to strip it and start again and practice does make perfect! One last thing - when you open your dollhouse, you can see all or most of the rooms at the same time so choosing your wallpaper to coordinate works better than having the rooms in colors and patterns that clash.

Karon


Sealing Wood: The best thing to use is also one of the cheapest. Go to the hardware store and get a small container of shellac and a small can of denatured alcohol (if you would prefer, you could probably go to the liquor store and get a large container of 151 rum -that way you could drink the rest if you run into too many problems with your house). Mix 5 parts alcohol to 1 part shellac. Brush it liberally onto the surfaces (it will dry in seconds). They are now sealed. If you are going to paint them, you can sand them at this point.

Tom Berkner


Sealing Wood: Use shellac, available in your hardware store, probably what they call 3 lb. cut. Shellac every single piece on both sides before you put it together preferably. Don't forget to do the edges also and make sure that they are coated well. I also paint before I assemble and use two coats of acrylic paint with a water based varnish to finish. You might prefer an oil based varnish or a polyurathane.

Barbara Del Duco


Wallpapering Tips: I cannot measure properly and even if I did, I would never be able to cut it correctly. Consequently, making templates of rooms is out for me. What I do is to paper the whole room including windows and doorways. I let it dry for a couple of days to make sure the paste is dry and then cut out the window and doorways with an X-Acto knife. If you don't let the paste dry, the paper will start to tear when you cut it. I don't care if the edges are not perfect, that's why molding was invented. It covers a multitude of sins. Corners present a special challenge and if the wallpaper corners don't meet, I put 1/4 round molding, painted a complementary color to the wallpaper, in the corners and you would never know that the wallpaper doesn't meet properly. The molding is barely noticeable. The wallpaper doesn't have to be perfect at the ceiling and floor because I use molding to cover that up. Of course, I have let out my secret on why there is so much molding in my dollhouses but, what the hey, I'm among friends.

Carol


Patching Stairway Hole: First I glue in a piece of wood that matches the thickness of the floor. (Sometimes I get that from a scrap, sometimes I buy aircraft model plywood which is pricey but very sturdy for the thickness. I often don't put in a divider for an attic room and use that). Many houses have punch outs that can be glued back in. Then take the scatter rug and glue it to a piece of aircraft plywood that is 1/16" thick and a little bigger than the cutout. Use Fun-Tac putty or similar material to fasten it gently to the floor over the patched hole. Use the spackled ceiling below the cutout. This is great for a little bit of reinforcement without permanently gluing on the rug, especially if your upstairs hallway won't always be that color.

Rebecca in Texas


Previous 10 | Next 10


Page 638 of 1032.

Total links in database: 10312.



Search for:


Browse the database (all entries)