Button Mold: you asked about molding a button.   I just did this recently using super-elasticlay.  I worked the elasticlay soft, rolled into a ball and then flattened it and pressed the button in pushing the edges up around but not overlapping.  Then I chilled the elasticlay with the button still in place. Once it was cold it held it's shape better when I gently removed the button. bake the elasticlay according to directions I used sculpy to then make the positive.   measure out the same amount for each piece you want to make, work till soft, roll into ball and press into the mold, working into all the relief.  chill again and gently work the mold free. bake sculpy.  I don't know about molding resin but would try it in a well ventilated area incase the two materials don't like each other.  Let me know how it works. 

Susan B Hanks


Making molds for casting: Micro-Mark has materials in their catalog to make molds for casting. I have the kit, haven't used it yet, looks like it should work.

Barb Jones


Preparing Eggshells: I am an egg artist and when we want to remove the membrane from an eggshell we soak the shell in pure bleach for about 10 minutes. This does make the shell much more fragile and also should be done in a well ventilated area so the bleach fumes don't bother your lungs.

Terry Ritchie


Sealing tubes: Painting craft glue across the tube end several times so it seals it off, that may work? as one can use membranes of white glue to make 'glass' in metal filigree caps used as lamp shades.

Helen Cottrell


Source of brass or silver jump rings:  make them yourself.  Brass wire's cheap, and so is silver plated brass.  Check your local jewelry supply store; you will need a thin knitting needle or something similar to wind the wire around, then snip it with your wire cutters.

An alternative would be to find a necklace or some chain with fairly round links at Michaels or Ben Franklin or similar stores in their jewelry parts sections, but then you're faced with taking them apart, which is very fiddly.

Karen Isaacson


Cobwebs: A good substitute for cobwebs--Pinch off a small piece of lint collected in your dryer and stretch it out and out.  Makes realistic cobwebs, especially if you have dried something gray in color.

Betty Martin


Cobwebs: A grey hair net will make excellent cobwebs. As for dust, I find it gathers fast enough all on its own.

Jayne Horsburgh


Water: I use the clear candle gel for water.   It's great if used in a dustproof roombox.  I have it dripping from a laundry tub, from a bucket, etc. - it stays shiny and I don't have to worry about mixing stuff together.

Theresa Thomas


Dust Test: Dust seems to be in-scale no matter how you apply it. See test results below: I made a test board by attaching a bunch of little wooden corners (wood scraps and broken/not-so-square picture frames) to a tongue depressor. Then I dipped the whole thing in Minwax stain and hung it out to dry over an air vent for a day. When I came home from work, I donned rubber gloves and sprinkled the following into the corners, blowing away some excess and touching it all up with Krylon matte spray.

Actual dust -- easy to find. Looked good, but tended to disappear after spray.

Grey dryer lint -- easy to come by. Was difficult to deposit in small enough particles, but the dust "kittens" that were in-scale looked good even after spraying.

Paint wash--got too wet and raised the wood grain. Seal wood first next time.

Pastel chalk -- only had green and purple in the house, but the right color has potential and is easy to apply. Hold small razored-off piece with tweezers, etc.

Fimo dust -- Have lots. Obtained fine particles by sanding over a mesh screen of the type intended to sand Sheetrock. Surprisingly effective. Used gray "granite" Fimo.

Lynn O'Shaughnessy


Inch to Metric Conversion Chart

Inches Millimetres
1/32" 0.08 mm
1/16" 1.58 mm
3/32" 2.38 mm
1/8" 3.18 mm
5/32" 3.97 mm
3/16" 4.76 mm
1/4" 6.35 mm
5/16" 7.94 mm
3/8" 9.53 mm
1/2" 12.7 mm
5/8" 15.9 mm
3/4" 19.1 mm
7/8" 22.2 mm
1" 25.4 mm

Garry Cosine


Previous 10 | Next 10


Page 712 of 1032.

Total links in database: 10312.



Search for:


Browse the database (all entries)