Bending Metal Tubing: I had to bend some tubing, and I had it for weeks and then my brother-in-law came along and I asked him for ideas. He stoked up our coal range and shoved my tubing in. When it had got red hot, he whipped it out and turned the cold tap onto it. It was then able to be carefully bent around a top of a plastic bottle. But once I had bent it once, it had to go back into the fire for more adjustments. It is great, not kinked - although it did kink because I wasn't confident enough to bend it firmly. But we straightened it out with heating it again. Just be careful that you hold it in the flames with something like tongs or such.

Diana in NZ.


Sharp Edges on Cut Tins: To finish cut edges on tins, an easy finish is to take some electrical flex, slit down one side and remove the wires, slip the hollow sleeve over the edges of the tin, maybe with a dab of glue to hold in place.

Maureen in Hemel, U.K.


Rainbow Designs: For those looking for the addresses of those who have taken over Rainbow Designs - here they are:

Rainbow Design Items (1" and Quarter Inch scales)
Paddy Culhane 604/988-5879
648 E. 5th St
North Vancouver, BC V7L 1M7, CANADA

Roo Glues

retail and wholesale - Sandy's Lace and Trim. Roo for Metal & Plastic will be called Roo MPG.

Sandy's 309/689-1943
7417 N. Knoxville
Peoria, IL 61614
www.sandyslace.com

Quarter Inch items (limited stock available)

K-Cee's Miniatures 330/547-5492
Karen Marsh
16383 Mock Road
Berlin Center, OH 44401
KMarsh4577@aol.com

Anker Templates for Duplicator

Smaller Than Life
Pete Boorum
79 Sebbins Pond Dr
Bedford, NH 03110
603/669-4185
smallife@nh.ultranet.com

Thin Glass
George Wrisley 503/653-2591
17784 SE Paradise Dr
Milwaukie, OR 97267

Susan from St. Croix


Alice's Zignettes: (room boxes created inside picture frames, based on literature) I added these photos to my photo album, so you can see what I'm talking about. Many of the frames were purchased as is, some I "doctored".

-To make glass block windows in the Sam Spade, Detective scene, I used a flat piece of glass that I bought at Michael's. It was made to hold a small pillar candle and is scored in small squares.

- In "In the Yellow Brick Road" I started with a plain flat frame, and added pieces of sculpey and wood carvings to suit the motif. I made the shapes and then baked them on the frame so they would be flat, then took them off and glued them back on after painting them.

- Did the frame for "Huck and Jim " basically the same way, except used netting on it and soaked it in Stiffy. Although you can't see it in the photo, I used resin for the river, and scanned the background picture from a book on rivers, painting the side walls to blend into the photo.

- In "Hercule Poirot" the raindrops outside the window were made by dripping clear nail polish on the glass (also works on acetate). The box was extended as the scene was wider than the frame I wanted to use.

- The "Alice in Wonderland" frame was purchased as is.

- In "A Study in Sherlock" I lined the velveteen of the draperies with heavy duty aluminum foil to create the folds and enable the fabric to "puddle" in a natural looking way onto the floor.

- I made the boxes out of 1/2" foam core, and each is lit with a bulb on a wire that are used for ceramic Christmas village houses. The outside of each box is covered with fabric that coordinates with the theme of the scene inside.

Alice Zinn


Painting Plastic: An easy way to paint plastic is to mix the paint with an Elmer's (white) type glue

Marsha in Vegas


STUCCO: When I made my Southwest roombox, I used a product called Sculptamold. It's a dry, white paper-type product that you mix with water. At first I was afraid it might soften or discolor over time, but I've had it at least six years, and it's just fine. It is pretty easy to work with. It should be mixed in small batches because it starts to dry fairly quickly, but you can add more water as you go, if needed. To make a niche, I cut an opening right through the plywood, then glued a piece of poster board to the outside of the box, and coated the whole thing with Sculptamold (just a thin layer inside the niche). Alice suggested cardboard tubes for the fireplace, and that works well. The only problem I had with this stuff is that it dries your hands out quickly, so I used disposable gloves.

Cheri


Quarter Scale Stucco: I am doing an 1/4" southwestern and I am using stair tread, both inside and outside the house. There were two southwestern magazines in Miniature Showcase and they did say that the insides should be stucco and white and that the outside were maybe a couple of other colors. I am doing the inside white stucco but doing the outside a pinkish-brown! I have also used the miniature stucco and that worked fine in 1".

Isabel Allen


Thought for various stucco (1" or 1/2" or 1/4," , etc.) sand comes in various sizes like fine; medium, etc., paint glue on surface drizzle sand on to glue; after dry shake of excess and paint. Or; mix proper size sand with Mod Podge and palate knife it onto surface.

Bob in Hollywood, FL


Painting Natural Materials: I agree with the advice to paint or seal natural materials. I purchased sheet moss from the craft store to cover the roof of Mossy Manor, and, later on, my hollow log house http://gerdesdesign.com/my_dollhouses.htm. This had been harvested and treated, and was bug-free. But over time it will lose its green and turn brown. After sealing it with hairspray, I painted it with "Basil" green florist spray paint -- the kind craft stores like Michaels carry -- it is much finer than regular spray paint. I felt the "Moss" color wasn't quite right and the Basil looked more natural. I didn't saturate it -- I left some natural showing so it would brown a little here and there (underneath, not in patches on the surface).

Now, several years later, it looks great and very natural.

Anne Gerdes


Circus: Place all your circus items in front of a painted backdrop of a red and white stripped circus tent entrance (use foam core to paint your scene or paste your picture). You may even embellish the painting or picture by using real stripped material as flaps on either side of the entrance perhaps with small "pegs" (pieces of toothpicks) attached to string to hold the flaps open. You could also use real material as flags along the painted flag poles that are always at the top of the tent

Marilyn of Michigan


Previous 10 | Next 10


Page 731 of 1032.

Total links in database: 10312.



Search for:


Browse the database (all entries)