Water Pellets (E-Z Water): I melt them in an old (cleaned) tin can that I've bent a pour spout into. It seems to come out pretty clear as long as you don't heat it too much. (There's a fine line there between not enough and too much). You have to be pretty quick at pouring it so be sure you know where you want it to go before you get it hot. You can scratch circles on the surface with a pointed metal object and then hit it with a heat gun and it will slightly melt the surface and look just like ripples. Also if it seems to lump up because it cools too fast after you've poured it, just hit it with the heat gun and it will smooth out. Be careful not to burn the surrounding scene. Jane |
Scenic Water: I just put a small amount in an old jar and stand this in a bowl of boiling water for a few minutes. I've not had any problems. Jayne Horsburgh |
Tacky Resin: If you are using the same container to measure your resin catalyst then that could be your problem. It's best to measure and pour the resin into a small container, then measure , pour the catalyst into a different container of the same size... then pour BOTH of those into a third container and stir carefully. That way you can be more certain that you've measured the two parts into EQUAL quantities. Viola Williams |
Tacky Resin: If your resin remains sticky, put it in the sun and the ultra violet rays will cure it. Marilyn |
Filler: My modeling filler of choice is Squadron white putty - which is sold at model shops that sell car kits, boat kits etc. It comes in a tube like toothpaste and I have used it to fill cracks and defects in wood, MDF, cardboard, plastic, resin and metal. Sandra in New Zealand |
Scenic Water: I had the same problem (not melting) at first and then I used really hot water almost boiling. I then poured the stuff directly from the can into the little baths. The bath bubbles came by pouring with a toothpick. The directions said to use an air blower but that didn't work out. One thing, the water was brownish which was realistic in my case since there are dirty and sandy toddler gnomes that just came out of the bath! Wilga |
Polyseamseal for Water. Sue Ann Thwaite's does not turn yellow with age. She uses the Darworth product. It might be a little more $ but we put so much time into our stuff and my time is worth it!! I have worked with this polyseamseal on cold days in a non-heated area and it was hard to work with. On hot days it flows almost too fast. You just have to adjust yourself... not the polyseamseal. http://ladybug-fairies.com Jan Haring |
Mixing casting resin: Be Exact, use 50-50. Too little hardener and its gooey forever. I have the best results when I am extremely exact. Velvet |
Water: In small areas, you can use Future Floor Wax for water. It takes a little while to set up, but becomes hard in several days, and it's very clear. I put some in a tiny brass fountain that I have. Not only did it harden, but the "water" turned a bluish-greenish color from contact with the brass, and it looks great in the fountain. It was a chemical reaction that I was not expecting but shows up better than clear water would. Future Floor Wax can also be colored to make things like orange juice, coffee, etc. Anita Myers |
Water: I had always used Envirotex but at Brooke's reflection pond class she had us get the casting resin from Michael's. It takes a few drops of hardener instead of the half to half and unlike Envirotex it comes out completely clear and sets up much faster. Anita McNary-Haynes |
| Previous 10 | Next 10 Page 764 of 1032. Total links in database: 10312. |
|
Browse the database (all entries) |