Kitchen Appliance Enamel: To get the appliance look to wood I have used the patching plaster in the little tubs. It is soft and all mixed for you. I use a credit type card and smooth the plaster on the wood very carefully and in a thin layer. Sand until smooth then do it again, and again. I paint it with a Enamel paint from the train and model car shop. Billie Joy Eller |
Kitchen Appliance Enamel: There are several ways to get a shiny finish on your furniture. One I've used was suggested by the old NutShell News. Cut a piece of white Contact Paper to cover the front of your appliance with a bit to overlap. Fold and smooth the edges onto the sides and top of the item, and then cover the other surfaces with Contact Paper, bringing it to about 1/16 inch of the edge. The second and third would be to apply several coats of Ceram Coat paint, sanding with a crumpled paper bag between coats, and if you are not satisfied with the gloss, topping it off with Future floor wax. Dani Rice, in Bradshaw |
Papa san or "round" chair is pretty easy to fake out of scraps. Materials: cheap woven straw hat (thrift shop), pizza-lid prop (preferably Y-top, but "table"-top will work), acrylic paint, tacky glue, fine upholstery braid or twine, fabric and stuffing optional. Tools: scissors, paintbrush, tennis ball, mesh fruit bag, twist-tie. Cut a 4-5 inch diameter circle out of the hat crown. Soak it in warm water till pliable and smooth it around a tennis ball. Wrap in mesh fruit bag and twist-tie in place. Meanwhile, turn your pizza prop upside down, snip about a 1/4 inch taper out of the leg ends (high end on outside, short end on inside). Paint to match wicker, faux bamboo, or wrought iron. Once the round seat piece is dry, remove from wrap and trim down so edges are even and the size looks to scale. Run a thin line of glue along the raw edge and cover with braid or twine (replacement yoyo twine at Wal-Mart). Dab tacky glue on pizza prop leg ends and pop seat on top, slightly angled, so "back" is a bit higher than "front." Let dry and you have a papa san. Add a seat cushion if you want - just cut a couple of fabric circles, stuff, stitch shut, and glue into chair. (I came up with this to use up the crown top after I used the rest of the crown with woven-in pattern as a sofa and arm chair.) Loretta Sniarowski |
Kitchen Appliance Enamel: I remember reading that Pat and Noel Thomas use enamel touch-up paint to get the enamel look on the Chrysnbon bath fixtures after painting them flat black. This might work for you too. Sue Helm, in Dallas, TX |
Kitchen Appliance Enamel: I use high-gloss spray paint for refrigerators, dishwashers, etc. Once you get the hang of using it, works real good. Looks good and shiny like enamel too. Dina |
Kitchen Appliance Enamel: Apple Barrell paint comes in gloss. I know they have white, black, green, gray, and red. They really are shiny. I used them on bathroom fixtures for my granddaughters house. Martha Simpson Nock |
Kitchen Appliance Enamel: I've tried this in the past and it seemed to work for me: Give your piece a coat of white glue (Elmers). Make sure you paint evenly and without brush strokes... may need several coats. When dry, paint with a glossy paint. I think the Yellow Booklet (from LollyInc@aol.com) has that hint in there somewhere, along with lots of other ideas. Viola Williams |
Kitchen Appliance Enamel: When I made the kitchen kit from Scientific Models, I used the spray refrigerator enamel sold at WalMart, etc, many light coats on the wooden base. Voila! Enameled stove and refrigerator. Patricia LeBeau in Florida |
Kitchen Appliance Enamel: When I did a modern kitchen and wanted that shiny enamel look, I shopped in my local hobby shop in the radio control car and plane section. I found this plastic sheet stuff that is used on RC planes. It had just the look I wanted. It's adhesive-backed. It seems thick when you buy it, but the part that peels off is very thin. The hardest part is getting it on w/out bubbles. The other option would be to use enamel spray paints. Trish in San Jose, CA |
Modern mini chairs: This site has some great contemporary chairs made of resin. I have the regency chair (not modern but wonderful) which is perfect 1:12 scale, so I imagine the others would be also. Someone mentioned chairs from a Bloomie's catalogue, that is where I got mine. This is the site and has more styles than the catalogue. They do not sell directly, but refer to retailers. http://www.takeaseat-by-raine.com If you can't get that site to come up, try this one: http://www.willitts.com Sydney |
| Previous 10 | Next 10 Page 875 of 1032. Total links in database: 10312. |
|
Browse the database (all entries) |